Installing aftermarket audio systems in vehicles can be a daunting task – especially when it comes to wiring. A Metra Line Output Converter (or LOC) takes the complicated wiring process out of the equation and makes it easier to install. However, before you can use the LOC, you need to understand the Metra Line Output Converter Wiring Diagram and how it works.
How Does a Metra Line Output Converter Work?
A Line Output Converter is a device that converts a speaker-level audio signal into a pre-amp level signal that can be used in an aftermarket audio system. The LOC is typically installed in the factory amplifier’s speaker-level output wires and provides a low-impedance output signal for the aftermarket amplifier. The LOC also provides a voltage signal to the aftermarket amplifier, which can be adjusted in order to match the factory amplifier’s voltage level.
Reading the Metra Line Output Converter Wiring Diagram
In order to properly install a LOC, it is important to understand the wiring diagram. The diagram will show you where to connect the LOC and how to connect it to the aftermarket amplifier. It will also show you the correct voltage setting for the aftermarket amplifier. The diagram also shows you how to connect the power and ground wires to the aftermarket amplifier and how to connect the speaker wires to the aftermarket amplifier.
Conclusion
Understanding the Metra Line Output Converter Wiring Diagram is essential for installing an aftermarket audio system in a vehicle. A Metra Line Output Converter simplifies the installation process by allowing you to easily connect the aftermarket amplifier to the factory amplifier’s speaker-level output. By following the wiring diagram, you can ensure that your aftermarket audio system is properly installed and functioning properly.
