Are you looking to install a Bennett trim tab system on your boat? If so, you’ll want to make sure you understand the wiring diagram that comes with the kit. Understanding how the system works and how it should be wired is an important part of the installation process. This article will provide an overview of how to read the wiring diagram for Bennett trim tabs.
Basic Components of the Wiring Diagram
The wiring diagram for Bennett trim tabs contains five main components. These are the power source, the tab actuator, the toggle switch, the trim tab indicator, and the trim tab control switch. The power source for the system is usually a 12-volt battery. The tab actuator is the part of the system that physically moves the tabs. The toggle switch is used to switch between trim tabs up and down. The trim tab indicator is used to show the position of the trim tabs. Finally, the trim tab control switch is used to control the speed of the trim tabs.
How to Read the Wiring Diagram
The wiring diagram for Bennett trim tabs is fairly straightforward. The diagram itself is divided into two sections. The top section shows the power source and the tab actuator, while the bottom section shows the toggle switch, the trim tab indicator, and the trim tab control switch. The diagram also includes labels that indicate which wires go where. The diagram also includes arrows to indicate the direction of the current.
To read the diagram, start at the power source. The diagram will show how to connect the power source to the tab actuator. Then, you can trace the wires to the toggle switch, trim tab indicator, and trim tab control switch. The labels and arrows will indicate how to connect each of these components correctly. Once all the components are connected, you can test the system to make sure it is working properly.
Conclusion
Understanding the Bennett trim tab wiring diagram is an important part of the installation process. The diagram contains five main components – the power source, the tab actuator, the toggle switch, the trim tab indicator, and the trim tab control switch. To read the diagram, start at the power source and follow the wires to the other components. Once all the components are connected, you can test the system to make sure it is working properly.
