Installing an ignition kill switch is a great way to provide additional security for your vehicle. Not only does it make it harder for someone to steal it, but it can also be used to disable your vehicle in the event of an emergency. However, there are a few things you should know before wiring your ignition kill switch.
Diagrams and Tools Needed
Before you begin, it’s important to have all the necessary tools and diagrams. At the very least, you will need a wiring diagram for your vehicle and the appropriate tools to make the connections. Additionally, you should also have a drill, wire cutters, and wire strippers. Depending on the vehicle, you may need additional tools and materials.
Steps to Wire Your Ignition Kill Switch
The first step is to locate the ignition switch. This is usually located on the steering column or instrument panel. Once you have located the switch, you will need to disconnect the power source. This can be done by unplugging the battery or by disconnecting the power wires from the switch. Next, you will need to connect the ignition kill switch to the ignition switch. This is done by connecting the wire from the switch to the power terminal on the ignition switch.
Once the connections are made, you will need to connect the other end of the wire to the ground terminal of the ignition switch. Finally, you will need to connect the other wire from the switch to the starter solenoid. Once all the connections are made, you can test the switch to make sure it works. If everything is connected correctly, the switch should turn the vehicle off when it is activated.
Conclusion
Wiring a simple ignition kill switch is a relatively easy job that can provide additional security for your vehicle. With the right tools and diagrams, it should only take a few minutes to complete the job. Remember to always disconnect the power source before making any connections, and to double check all the connections before testing the switch.
