If you have a boat with an outboard motor, you may need to wire a 3 wire tilt trim motor at some point. This motor is responsible for adjusting the tilt and trim of the motor, which can come in handy when you need to change the position of the motor. To wire this motor, you will need to follow a few simple steps.
Step 1: Identify the Connectors
The first step in wiring a 3 wire tilt trim motor is to identify the connectors on the motor. There should be three connectors in total – one for power, one for ground and one for the trim/tilt control. Make sure that you label each connector so that you don’t get confused later on.
Step 2: Connect the Power and Ground Wires
The next step is to connect the power and ground wires. Connect the power wire to the positive connection on the motor, and the ground wire to the negative connection. It is important to make sure that the connections are secure and that you have the correct polarity, as this will help to ensure that the motor runs properly.
Step 3: Connect the Trim/Tilt Control Wire
The last step is to connect the trim/tilt control wire. This wire should be connected to the trim/tilt connector on the motor. Make sure that the connection is secure and that the wire is connected with the correct polarity, as this will help to ensure that the motor operates properly.
Conclusion
Wiring a 3 wire tilt trim motor is a relatively simple process. By following the steps outlined above, you should be able to get the motor up and running in no time. Just make sure that all connections are secure and that you have the correct polarity, as this will help to ensure that the motor works properly.
