Starter solenoids are an integral part of the Johnson outboard motor. They provide the necessary power to start the motor and keep it running. A faulty starter solenoid can cause the motor to not start, or to run inconsistently. Knowing the wiring diagram of your Johnson outboard motor can help you troubleshoot the problem and get your boat back in the water.
Understanding the Wiring Diagram
The Johnson outboard starter solenoid wiring diagram is fairly straightforward. It consists of two main components: the starter and the solenoid. The starter is mounted on the outside of the motor, while the solenoid is located inside the motor. The two components are connected by a large red wire, which is the main power source. The starter is connected to the solenoid by two smaller wires, one black and one white.
Testing the Wiring
Once you have identified the components, you can begin to test the wiring. First, check the connections between the starter and the solenoid to ensure that they are secure. If the connections are loose, tighten them. Next, test the continuity of the wires. Make sure that the wires are free of damage and that there is no short circuit between the starter and the solenoid. Finally, test the voltage of the red wire to make sure that it is within the recommended range.
Conclusion
Understanding the Johnson outboard starter solenoid wiring diagram is essential for troubleshooting and repairing your motor. With a little bit of knowledge and some basic testing, you can easily identify any problems with the wiring and get your boat back in the water. For more detailed information on outboard motors, check out your local marine supply store or online retailer.
